11-03-2012 06:06 AM - edited 11-03-2012 06:13 AM
Hi, after running the utility (USB device viewer) mentioned on one of the thread in this forum I am getting this message
Current Config Value: 0x00 -> Device Bus Speed: Low
Device Address: 0x00
Open Pipes: 0
*!*ERROR: No open pipes!
*!*ERROR: bLength of 0 incorrect, should be 18
*!*ERROR: Device enumeration failure
Please advice what to do!
I tried to disconnect, uninstall using device manager, then reconnect. But didnt work.
On device manager I am getting :
This device is disabled because the firmware of the device did not give it the required resources. (Code 29)