Barracuda XT, Barracuda, Barracuda Green, DiamondMax and other desktop SATA and IDE drives

[yoyo]

Hello everyboby

i'm need firmware SD15 for my disk

my disk is:

http://img256.imageshack.us/img256/2237/20120502003104358.jpg

i'm upgrade firmware SD15 to SD1A but i'm not recovery my data

possible cancel firmware SD1A?

very thanks you for réponse

[Cantbecanit]

If you do that it will brick on you

Not sure what you think has happened as it looks like you aren't English speaking, but I suspect you think putting the old FW on will revert the drive back so you can read old data, if you flashed it properly the data should be readable still anyway, if you like write what you want to say in you native language and use google translator and then convert it to English and post it here.

[yoyo]

good morning yes I want the old re-installed firmware. for recovered of old given. you think that I can recovered my data with the firmware S1A while the disc is not repaired?

with seatools, I have an error SMART, test runs echec, long echec test. the disc is visible in ' management of the computer under windows ', partition am non-initialized, and when I initialize I have the choice between partiiton standard, and GFT partition, its 2 cases create an error E/S

what lane I can again explore?

warmly

[yoyo]

after a reboot I did not have more acces in the disc via the bios, it appeared no leave.

a person on Internet me made whizz the manip to re-watch over the hard disk with mode RS232, I have acces in the disc via BIOS once again, but it shows 0Mb

EASUS recovery does not work


the firmware SD1A it is correctly installed, without any probleme


my PC is decelerated with the connected up hard disk

[yoyo]

[Cantbecanit]

Ok, so after putting SD1a on it the drive is appearing only as an 8GB drive and no data?

I notice you have it set up with an SSD and I think this could be where the issue is, what I would suggest is to remove the Seagate and slave it to another working PC and see if the data becomes readable, how are you using the SSD, Raid 0 or SSD master Seagate slave?

If it's a master and slave and you are using Intel, reload the RST driver's, and I would check for FW updates to the SSD, I know both the OCZ and Crucial drives have both recently had new FW's,

If it's in Raid 0 which I don't think it will be because I shouldn't be able to see the SSD at all if it is, you will need to re-configure the raid set up in the Intel console.

Anyway, if the drive is showing up, simply slaving it to something more conventional should make it fully readable in Windows.

[yoyo]

my mere card is P35 DS3R

I have of port SATA intel x6 and port sata gigabyte x2

yesterday, windows does not start any more, I have of change sata of harbour so that it arrives have launch

I know there nothing at all in raid, you can give me a little more details?

in HDtune 2000giga... it is unpredictable

thank you in advance