I need advise that is my drive failing according to the SMART status?
I have two ST3000DM001-9YN166 with firmware CC4C and below are the SMART information.
http://www.hddstatus.com/hdrepshowreport.php?ReportCode=6182164&ReportVerification=9D58868A
Attribute Current Raw
Raw Read Error Rate 119 00000C2539A0
Spin Up Time 92 000000000000
Start/Stop Count 100 000000000009
Reallocated Sector Count 100 000000000000
Seek Error Rate 39 04B8007C12D7
Power On Hours Count 99 00000000043D
Spin Retry Count 100 000000000000
Power Cycle Count 100 000000000009
SATA Downshift Error Count 100 000000000000
End To End Error Count 100 000000000000
Reported Uncorrectable Errors 100 000000000000
Command Time Out 100 000000000000
High Fly Writes 100 000000000000
GSense Error Rate 100 000000000000
Power Off Retract Count 100 000000000006
Load Cycle Count 100 000000000038
Current Pending Sector 100 000000000000
Offline Uncorrectable Sector Count 100 000000000000
Ultra DMA CRC Error Rate 200 000000000000
Write head 100 D18C0000043C
Total LBAs Written 100 000EFF129454
Total LBAs Read 100 00039D1FCDBA
http://www.hddstatus.com/hdrepshowreport.php?ReportCode=6182165&ReportVerification=7AD7C066
Attribute Current Raw
Raw Read Error Rate 119 00000D82A908
Spin Up Time 92 000000000000
Start/Stop Count 100 000000000008
Reallocated Sector Count 100 000000000000
Seek Error Rate 69 0000007972B9
Power On Hours Count 99 00000000043D
Spin Retry Count 100 000000000000
Power Cycle Count 100 000000000008
SATA Downshift Error Count 100 000000000000
End To End Error Count 100 000000000000
Reported Uncorrectable Errors 100 000000000000
Command Time Out 100 000000000000
High Fly Writes 94 000000000006
GSense Error Rate 100 000000000000
Power Off Retract Count 100 000000000005
Load Cycle Count 100 000000000052
Current Pending Sector 100 000000000000
Offline Uncorrectable Sector Count 100 000000000000
Ultra DMA CRC Error Rate 200 000000000000
Write head 100 532E00000439
Total LBAs Written 100 0C054C4C3D67
Total LBAs Read 100 010905683639
I noted that on one of the drive the value of Seek Error Rate dropping near threshold level. Should i take preventive action before something bad happens?
Seatools have failed me once by reporting the drive is ok and the next day the drive fails.
