01-12-2010 03:25 PM
Just a couple of hours ago I was wondering IF I would have managed to migrate the entire content of my unique IDE HDD to the new Seagate SATA HDD. After spending some time reading SATA topics on many different forums I was sure that, if possible, it would have been a hard and time-consuming process.
Then I had a close look to the Seagate HDD's label, and noticed a link to a promising tool.
So I downloaded, installed,run DiscWizard and now the old IDE disk is disconnected, yes, I'm using the new SATA disc.
The entire process, from hardware setup to this Internet connection barely took two hours. No problems at all.
So I wish to say Thank You to Seagate, and WELL DONE!.
Stefano - Italy.
Solved! Go to Solution.
01-15-2010 07:11 AM