salsiccia wrote:
Hi Jim,
Thanks for that thought, but I'm curious about your mention of a "tool". The only tool I am using is my own clumsy finger to hit the reset button ! Maybe the button is a bit different on the Go Flex, but on the FAT+ the button protrudes and I don't think I need a tool to press it in, but maybe that's part of my problem!
Anyway, I tried the US 1.55 firmware process recommended above and that made some progress in that it seemed to recognise the image on the USB and it tried to install it, and reported that it was trying to do that, but the end result was the same. Just the Seagate logo on the screen and the orange power LED flashing.
If anyone else has any brilliant ideas, I'm all ears !!!
Sal
Sal,
When you said "it reported that it was trying to do that", what was showing on the screen? after that, when was the Seagate logo appear? was there any count down or message that you can copy down and post here?
Also, can you tell while the FAT+ being stuck with the logo, did your router assign an IP address for the FAT+? If the FAT+ actually got an IP address at that point, you can try to telnet in. I know, this is farfetched, but we don't really know what causes this "Seagate Logo stuck on screen" problem :-) I'm trying to "see" if it even got through the booting process after the flashing (if it was done). Usually, when the flashing sequence starts, the update message appears, and then the blank screen for a "long" time (be patient), then shows a counting down message, then reboots.
-------------
Feedback! when asking for help, please remember to let others know whether the suggested solution has solved the problem or not.
Need FAT+/GoFlex TV help? see this thread: http://forums.seagate.com/t5/FreeAgent-Theater-and-GoFlexTV/FreeAgent-Theater-product-page-and-other-information/td-p/76254
